|
|
Solution Page
The remanufactured Canon CL-246XL (8280B001AA) cartridge that I Refilled is not accepted by the printer
There could be a problem with the electronic connections
between the cartridge and your machine that
needs to be corrected:
- Using isopropyl (rubbing) alcohol, clean off the electronic strip on the cartridge. You can use canned air to remove
any debris that might be on the area in the machine that reads the electronics on the
cartridge, or you can blow on the area in the machine to remove any loose
debris that is present.
NOTE: Cleaning both the cartridge and the machine this way will help
to ensure a good connection between the two.
(A3) |
|
The cartridge may not be sitting in the printer quite right:
- Take the cartridge out of the machine.
- Make sure that there is nothing on the cartridge that would stop it from
sitting properly in the machine.
- Place the cartridge back into the machine making sure that it is in the
machine straight and that it is properly secured in its slot.
(A2) |
|
Check the electronic strip on the cartridge for damage:
- These electronic strips
are very sensitive and they can get physically damaged by bumping them (dropping
the cartridge is one way this happens), or tearing them by catching them while
pulling them out of your machine, or even with one of your fingers. There
is no repair for this. You will need a new cartridge.
(A11) |
|
Click Here to buy a remanufactured Canon CL-246XL (8280B001AA) Cartridge or Refill Kit
|