|
|
Solution Page
The remanufactured PG-40 (Canon 0615B002) cartridge that I Refilled is not accepted by the printer
There may be a problem with the connection between the
chip on the cartridge and the chip reader in the machine:
-
Remove the cartridge from the machine.
- Clean off the chip on the cartridge with isopropyl (rubbing) alcohol to ensure a good
connection.
- It is a good idea to clean the area in the machine that reads the
chip on the cartridge as well. You can use canned air to remove any
debris that might be on the area in the machine that reads the electronics on the
cartridge, or you can blow on the area in the machine to remove any loose
debris that is present.
NOTE: Cleaning both the cartridge and the
machine this way will help
to ensure a good connection between the two.
(A9) |
|
The cartridge may not be sitting in the printer quite right:
- Take the cartridge out of the machine.
- Make sure that there is nothing on the cartridge that would stop it from
sitting properly in the machine.
- Place the cartridge back into the machine making sure that it is in the
machine straight and that it is properly secured in its slot.
(A2) |
|
Check the electronic chip on the cartridge for damage:
- These electronic chips can get physically damaged by bumping them on
something, or even dropping
the cartridge can cause visible damage. Also, the pads on these cartridges
can wear down after multiple uses making it impossible for the machine to
read them properly. There is no repair for this. You will need
to get a new cartridge.
(A12) |
|
Click Here to buy a remanufactured PG-40 (Canon 0615B002) Cartridge or Refill Kit
|